How to test fuel injectors for pulsing. Learn how to check fuel injectors. I use a screwdriver to test fuel injectors to make sure they are firing. You place a long screwdriver to the base of each injector and put your ear to the end of the screwdriver (like a doctors stethoscope). You should hear constant clicking. If not, then your injector isn’t firing or is firing intermittently.
Symptoms of bad injectors are a check engine light with codes P0300 through P0308, misfiring, hesitation, poor fuel economy, stalling, and a poor idle.
Using a Multimeter to Check Fuel Injector Resistance: https://www.youtube.com/watch?v=ZVXchvHefNc
**If the video was helpful, remember to give it a “thumbs up” and consider subscribing. New videos every Thursday**
-Website: https://www.ChrisFixed.com
-Facebook: https://www.facebook.com/chrisfix8
-Twitter: https://twitter.com/ChrisFixed
-Instagram: https://instagram.com/chrisfixit
-Subscribe Here: http://www.youtube.com/subscription_center?add_user=paintballoo7
-YouTube Channel: https://www.youtube.com/ChrisFix
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.
