BRZ Resurrection Pt 29 – Mounting Side Skirts and Bumper

In this episode Chris goes over mounting rocket bunny v1 side skirts as well as finalizing the bumper and mounting it to the car.

http://bisforbuild.com
http://bisforbuild.com/#shop
http://facebook.com/bisforbuild
http://instagram.com/bisforbuild

Music:
04:11 – Brig – Spoil
05:24 – Can’t Stop (RIOT Remix)
13:49 – Killabyte – Our Story

source

Author: avnblogfeed

ANGELHOUSE © 2009 - 2022 | HOSTING BY PHILLYFINEST369 SERVER STATS| & THE IDIOTS ROBOT AND CONTROL INC. |(RSS FEED MODULE)| ALL YOUTUBE VIDEOS IS A REGISTERED TRADEMARK OF GOOGLE INC. THE YOUTUBE CHANNELS AND BLOG FEEDS IS MANAGED BY THERE RIGHTFUL OWNERS (AVNBLOGFEED.COM)

44 thoughts on “BRZ Resurrection Pt 29 – Mounting Side Skirts and Bumper

  1. Thank you for the threading clip tip on the bumper support!!!! I will be using that as my fender studs are toast. big thanks as that's a load off my mind I had to figure out

  2. Would you have had any issues installing the FR-S bumper on the BRZ if it were not for the wheel fitment issues? Was it a simple bolt on?

  3. I think some seam sealer around the areas under the hood where you used the sheetmetal would be a good idea, just for rust. Make sure to coat both sides!

  4. Car is looking sick Chris ! wasn't liking the wheels at first but they are growing on me. It's unreal looking. Good job

  5. Now that the Plan A is almost done, you can finish the Plan B and hit PARC as soon as possible. And pls don't forget your cameras as well as putting that shit on YT.

  6. usually people who run the rocket bunny kit would either have super stiff coilovers or run air bags to raise it away from rubbing

Comments are closed.