Join us in the shop as we begin to prep the skid loaders for the Easy Money rental fleet. We needed to get the decals off and prep these for paint. New decals will be on the way soon and these will get rented out as soon as spring hits. HOPEFULLY! Enjoy
Sledge is #1 unnecessary but the mount is gonna tear clothes & fillet someone!
As you peel, the corner of those decals and continue to pull them off, you know how you get a little bit of extra, fold the decal over on itself. Stick the adhesive side to the adhesive side of what you’re peeling & keep doing that. it will strengthen that edge and keep it from breaking right at the Intersection of the sticker in the machine.
The entire time I'm like why don't you put the circular saw on the table? 😂
Also a vice attched to the tablet
Why aren't you putting your tablespoon on the table?Isn't it going to make it easiest in bending down
Bro putting his fingers in other cups and putting them back is wild
Do any of your truck take death?
You could have retractable electric power in different areas of the shop so you can keep the power cords off the floor.
Also, if the table is permanent in its place, have overhead lighting above the table.
How about a power bank for all your batteries.
Super late comment, But should just incorporate some drawers on that table!! And some shelves and storage area underneath to hold maybe lumber and what not? That's what I would do anyway..
Mount a cup holder on the side of the work bench. The coffee can never get spilled that way.
Give your millwalkee tools to ceo danial
36:17 I have that glove holder you need to bend the metal tabes to hold the gloves tighter.
Maybe try renting your Milwaukee tools out as well. Maybe add tools to your rental buisness. 🌿🕊ï¸
Hi Ryan, I'd put heavy duty lockable Castor wheels on the bench also bore some holes on the legs at an angle for pry bar's
Good work!
if you were with Milwaukee all those cool holders you were looking at at harbor freight would be from them. Milwaukee has by far the greatest tool storage platform
I would put some electrical outlets on the bench with some battery chargers
You put one of those cups back after your hands were in it…never film that again…lol
We put wheels on our table in our shop so we could move it around the shop
Try use warm it up then use soap and go over it with a window smoothscraper. Aslong as u use soap and becareful i think it should go off faster. Not sure tho but it helps for windows😂
A base to place your chop saw flush with the top of your work table
Ryan, don't know if this idea has been thrown out there, but if you plan to do a lot of welding on that table, a round piece of pipe to put your stinger in, in between welds, is helpful. Keeps your stinger out of the way and makes sure it won't get knocked on the floor or something like that
Ryan you do good 5S in your shop without even knowing it.
Those sharp corners on bench still mess with me.
we made a stand for our grinders and it helped alot. steel plate with a semi-circle cut out to rest it on. also for a pen holder u could use a 3-4 inch long piece of square tubing at a 45 degree to hold markers and pens
Your welding helmet
Should put a torpedo heater close to the skids to remove the stickers faster
It would be cool if there was some heavy duty magnet strips for your stuff to put on that table
Francisco new nickname "Doc" because he has plenty of "patience" 😂
Dewalt has 20v air sprayers it sprays paint good
I’m probably late but you could hang the sledge sideways.
you should add cords coming from the ceiling where the table is at. Easy to access and less of a trip hazard
Power bar mounted to the table
GREAT Idea on welding the tool box, I’m going to do that in my Shop!