Go to https://chomps.com/SAMCRAC15 and use code SAMCRAC15 at checkout to get 15% off and free shipping on your next Chomps order!
I saw this machine for $150 on a Chinese Marketplace Site that claims to Erase Door Dings and Car dents within seconds. How bad could it be???
Instagram: https://www.instagram.com/samcracc/
Facebook: https://www.facebook.com/SamcracAuto/
Email Me: Sa*********@***il.com
With he amount of time I spent waiting for the panels to cool down while using this thing, I could've actually finished like 3 projects. At least I had the best snacks to keep me motivated! Go to https://chomps.com/SAMCRAC15 and use code SAMCRAC15 at checkout to get 15% off and free shipping on your next Chomps order!
Try using it with the pdr basic set their a lot of nasty dents I’ve needed to get out that with a little heat like this would have helped a lot
I would try pre heating with hair dryer or something similar. To get to go back to original shape.
You should keep an ice pack in a bag and when it heats, quickly chill it and it will hold btter
Cured meat ?😂
that machine is BS, lol go to a real PDR guy !
You were not using it right, I charge $100 to show you how to use the magic machine
the machine its junk
Where did you get the light from
Cool it right away with a wet cloth
What do you do with plastic cars?
First off, heat expands – it doesnt shrink.
secondly it is just an induction heater.
if its electro magnet increase the The voltage so it will pull harder.
Waste of money
a Technique for bending pipe and beams is to heat up the side that you want to be concave, because while metal expands when heated it shrinks even smaller than it was originally, at least when it reached grain growth temps
Try an ice cube on a hot day
Alternating heat and cold is what makes the surface flex back into its original shape. Without the crucial cooling step, the dent remains unchanged because of thermal expansion/contraction. Apply the emitter to the affected area, then blow cold air to "freeze" the area from flexing back to its dented state for positive results. Reapply as needed.
👌ðŸ»ðŸ‘ŒðŸ»
Using tvos while doing pdr Nd softening the metal right before pushing out out would make the results alot better and faster.
Hit the other button and leave it on power percentage and increase it. it will hit harder and you can’t go right on the dent until the last few steps.
Does this work on aluminium panels?